12008 Power Supply Failure POWER: Drum Amp Fault All Reset the machine, if the fault does not go away, power off the machine and start up again. If the fault is reported again after the machine is initialised, type <drum init> at the monitor. It may help to leave the machine off for 20 minutes if the fault was caused by high temperature. The error "Servo amp fault" (error code 6011) is also generated by this same error condition. Extensive troubleshooting information can be found by referencing error 6011. ../error_messages/06011.xmlE_DRUM_SERVO_AMP ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:42 2008 PST